Fuentes, Andres

The main characteristics of pool fire flames are flame height, air entrainment, pulsation of the flame, formation and properties of soot particles, mass burning rate, radiation feedback to the pool surface, and the amount of pollutants including soot released to the environment. In this type of buoyancy controlled flames, the soot content produced and their subsequent thermal radiation feedback to the pool surface are key to determine the self-sustainability of the flame, their mass burning rate and the heat release rate. The accurate characterization of these flames is an involved task, specially for modelers due to the difficulty of imposing adequate boundary conditions. For this reason, efforts are being made to design experimental campaigns with well-controlled conditions for their reliable repeatability, reproducibility and replicability. In this work, we characterized the production of soot in a surrogate pool fire. This is emulated by a bench-scale porous burner fueled with pure ethylene burning in still air. The flame stability was characterized with high temporal and spatial resolution by using a CMOS camera and a fast photodiode. The results show that the flame exhibit a time-varying propagation behavior with a periodic separation of the reactive zone. Soot volume fraction distributions were measured at nine locations along the flame centerline from 20 to 100 mm above the burner exit using the auto-compensating laser-induced incandescence (AC-LII) technique. The mean, standard deviation and probability density function of soot volume fraction were determined. Soot volume fraction presents an increasing tendency with the height above the burner, in spite of a local decrease at 90 mm which is approximately the position separating the lower and attached portion of the flame from the higher more intermittent one. The results of this work provide a valuable data set for validating soot production models in pool fire configurations.

A novel diagnostic is proposed to characterize the maturity of soot particles in a laminar axisymmetric coflow ethylene diffusion flame in terms of the spectral dependence of soot absorption function. The method relies on the combination of line-of-sight attenuation (LOSA) and emission measurements at four wavelengths (500, 532, 660 and 810 nm). The analysis of the measured signals enables the determination of soot temperature, soot volume fraction, soot maturity and the contribution of soot scattering to extinction. The analysis of extinction and emission measurements considers the spatial variation of soot optical properties. The introduction of a maturity index allows the evaluation of soot maturity based on the spectral variation of the soot absorption function. The maturity index is correlated with the organic or the mature soot content and finally in terms of the absolute value of absorption function at 810 nm. The methodology is validated using a set of synthetic spectral LOSA and emission signals representing experimental measurements based on numerical results obtained using the CoFlame code. A sensitivity analysis of the Abel inversion is also performed to properly address the effect of deconvolution procedure. Finally, the proposed method is applied to analyze the experimental data of spectrally-resolved LOSA and emission acquired in a laminar axisymmetric coflow ethylene diffusion flame established on a G¨ulder burner. The two-dimensional distributions of soot temperature, soot volume fraction, soot maturity, and the ratio of total scattering to absorption are determined. Mature soot particles are found on the top of the flame in the centerline region and also in the outer edge of the flame wing displaying strong gradients.