Lazo, Andrea

The analysis of Cu distribution in pre-treated mine tailings after electrodialytic remediation was carried out by using two methods of sequential extraction. The initial content of copper in the tailings was 1109 mg Cu/kg of dry tailing, where close to 40% of the sample in weight corresponded to a soluble fraction. The tailing was treated with a leaching solution for 24 h. Three different solutions were tested: H2SO4 + HNO3 with pH = 1.9; H2SO4 + HNO3 with pH = 4.2; and NH4Cl 0.8 mol/L with pH = 5.5. After that, electrodialytic remediation experiments were carried out using an electric field of 2.7 V/cm for 15 days. The best performance for the complete cell was obtained with H2SO4 + HNO3 solutions, with a copper removal efficiency in the range of 62% to 67% and a current efficiency between 6% and 9%. The results of the remaining copper concentration between anode and cathode, from both procedures of sequential extraction, showed similar trends. The differences were mainly attributed to the use of different extractant solutions and extraction times. Soluble and exchangeable fractions were easily removed, with efficiencies higher than 80%. The lowest copper removal efficiency was obtained with NH4Cl 0.8 mol/L.

In Chile, there are several abandoned mine tailing impoundments near population centers that need to be remediated. In this study, the ability of Oxalis gigantea, Cistanthe grandiflora, and Puya berteroniana to remove Zn, Ni, and Cr from mine tailings was evaluated. The plants’ removal efficiency, bioconcentration, and translocation factors regarding these metals were determined to assess the ability of certain endemic species from Northern and Central Chile to extract or stabilize metals. After a period of seven months, the chemical analysis of plants and tailings, together with the statistical treatment of data, indicated the inability of all the species to translocate Ni, Cr, or Zn with a translocation factor lower than one. The results showed the stabilizing character of Oxalis gigantea, Puya berteroniana, and Cistanthe grandiflora for Zn, with a bioconcentration factor close to 1.2 in all cases, and the same ability of the latter two species for Cr, with a bioconcentration factor of 1.5 in the case of Cistanthe grandiflora and 1.7 for Puya berteroniana. Finally, a removal efficiency of 9.3% was obtained with Cistanthe grandiflora for Cr and 15% for Ni; values lower than 6.4% were obtained for Zn in all cases. Improvements in the process should be sought to enhance the performance of these species for the accumulation of the target metals.