Thesis: Valorización de relave calcáreo para el tratamiento de drenaje ácido
Date
Authors
Journal Title
Journal ISSN
Volume Title
Degree
Campus
Publisher
Abstract
La presente investigación evaluó la valorización de un relave calcáreo proveniente de la Planta Cerro Blanco de Polpaico como medio reactivo alcalino para el tratamiento de drenaje ácido de roca (DAR) sintético, considerando su capacidad de carga, remoción de metales disueltos y aplicación en sistemas de percolación. La investigación se desarrolló bajo un enfoque de economía circular, evaluando la valorización del relave calcáreo como medio reactivo para el tratamiento de DAR. El relave fue caracterizado química, mineralógica y fisicoquímicamente. La espectroscopía Raman evidenció una matriz dominada por calcita, junto con la presencia minoritaria de cuarzo, mientras que la caracterización química mediante digestión ácida determinó un contenido de Ca de 26.72 %, correspondiente a un equivalente teórico aproximado de 66.7% de CaCO3, considerando el calcio asociado a fases carbonatadas. La capacidad de carga del relave fue evaluada mediante ensayos batch, con el objetivo de determinar su potencial de neutralización y remoción de metales. El pH aumentó desde 1.39 hasta 6.51, evidenciando una alta capacidad de neutralización y una elevada remoción de Fe, Cu y Pb, mientras que el Zn presentó una menor respuesta. Adicionalmente, se realizó un ensayo con el doble de concentración metálica del DA, con el objetivo de someter el material a una mayor carga y estimar su capacidad máxima de carga. Bajo estas condiciones, las capacidades de carga alcanzaron 10.16 mg/g para Fe, 4.76 mg/g para Cu, 2.50 mg/g para Zn y 2.39 mg/g para Pb. Posteriormente, el relave fue evaluado en columnas de percolación mediante cuatro configuraciones experimentales, variando la altura del lecho reactivo y la incorporación de capas intermedias de cuarzo. Durante los ensayos se monitorearon (...).
This study evaluated the valorization of calcareous tailings from Polpaico’s Cerro Blanco Plant as an alkaline reactive medium for the treatment of synthetic Acid Rock Drainage (ARD), considering their metal loading capacity, removal of dissolved metals, and application in percolation-based treatment systems. The study was conducted within a circular economy framework, assessing the potential reuse of calcareous tailings as a reactive material for acid drainage treatment.The tailings were characterized in terms of their chemical, mineralogical, and physicochemical properties. Raman spectroscopy indicated a mineral matrix predominantly composed of calcite, with quartz occurring as a minor phase. Chemical characterization by acid digestion determined a Ca content of 26.72 wt.%, corresponding to an approximate theoretical CaCO₃-equivalent content of 66.7%, assuming that the measured calcium is associated with carbonate-bearing phases. The metal loading capacity of the tailings was evaluated through batch experiments to determine their neutralization potential and metal removal performance. The solution pH increased from 1.39 to 6.51, demonstrating a high acid-neutralization capacity and substantial removal of Fe, Cu, and Pb, whereas Zn exhibited a comparatively lower removal response. In addition, a batch test using twice the initial metal concentration of the synthetic AD was conducted to expose the material to a higher metal loading and estimate its maximum loading capacity. Under these conditions, metal loading capacities of 10.16 mg/g for Fe, 4.76 mg/g for Cu, 2.50 mg/g for Zn, and 2.39 mg/g for Pb were achieved. Subsequently, the calcareous tailings were evaluated in percolation columns using four experimental configurations, in which the reactive-bed height and the incorporation of intermediate quartz layers were varied. Throughout the experiments (...).
